自动焊接机工作速度较快，深度较大，不易变形。可以同时进行多束加工和多工位加工，使焊件更加准确。下面来讲讲山东自动焊接设备的检查与注意事项。

The automatic welding machine has fast working speed, large depth and is not easy to deform. Multi beam processing and multi station processing can be carried out at the same time to make the weldment more accurate. Now let's talk about the safety inspection and precautions of Shandong automatic welding equipment.

自动焊接设备检查：

Safety inspection of automatic welding equipment:

操作员在每次焊接操作前要检查以下项目：

The operator shall check the following items before each welding operation:

1.确保焊接机相互良好的接地是可靠的安装。

1. Ensure that the welding machine is reliably grounded.

2.确保焊接机的输入和输出电缆完好无损。

2. Ensure that the input and output cables of the welding machine are intact.

3.安装并固定了焊接机后，专门的人员要定期对其进行检查。

3. After the welding machine is installed and fixed, special personnel shall inspect it regularly.

4.不会有内部间隙等异常情况。检查并确认送丝辊的凹槽和齿型完好无损，并且在磨损或接触不良时应更换辊和接触头块。

4. There will be no abnormal conditions such as internal clearance. Check and confirm that the groove and tooth profile of the wire feeding roller are intact, and replace the roller and contact head block in case of wear or poor contact.

使用自动焊接设备的注意事项：

Precautions for using automatic welding equipment:

1.焊枪电缆不要压得太紧，弯曲角度也不能太小。送丝软管的半径不应小于150mm，否则内部电缆会损坏，可能导致事故。焊接期间请勿更改电压调试开关。

1. The welding gun cable shall not be pressed too tightly and the bending angle shall not be too small. The radius of wire feeding hose shall not be less than 150mm, otherwise the internal cable will be damaged, which may lead to accidents. Do not change the voltage commissioning switch during welding.

2.在焊接操作过程中，请勿触摸带电部件，例如焊接机的输出接口。

2. During the welding operation, do not touch the live parts, such as the output interface of the welding machine.

3.更改或调试面板旋钮时，请勿过分用力。自动不锈钢管焊接机可能会损坏设备。

3. Do not use excessive force when changing or debugging the panel knob. Automatic stainless steel pipe welding machine may damage the equipment.

4.每次焊接之前，请检查焊接机的连接是否正确以及接地线是否可靠。

4. Before each welding, please check whether the welding machine is connected correctly and whether the grounding wire is reliable.

上述是为大家介绍的使用自动焊接设备的注意事项，相信大家阅读完文章之后对这一问题有了新的了解和认识，如果您想了解更多知识，欢迎多多关注我们的网站http://www.tayfsk.com动态。

The above are the precautions for the use of automatic welding equipment. I believe you will have a new understanding of this issue after reading the article. If you want to know more, please pay more attention to our website http://www.tayfsk.com Dynamic.